Publicidad
Idiomas disponibles
Idiomas disponibles
USER REPLACEABLE
SERVICE
PARTS
REPLACEMENT
PART
Container
of Replacement
Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
Edge Guide
'_
WARNING:
Perform the following
PART NUMBER
71-85907
530403805
530403886
530016152
530404393
530403845
steps after each use.
• Stopthe
unit and disconnect
the pow-
er source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter blade
cannot cause injury.
• Store unit and extension
cord indoors
in a high, dry place out of the reach of
children.
Store unit unplugged.
• Store
unit with all guards
in place.
Position unit so that any sharp object
cannot accidentally
cause injury.
TROUBLESHOOTING
TABLE
WARNING:
Always stop unit and disconnect
from tile power source before
performing
all of the recommended
remedies below except remedies that re-
quire unit to be operating.
TROUBLE
CAUSE
REMEDY
Trh-nmer head
1. Crowdh_g line against
1. Allow tip of Ih_eto do the cutth_g.
stops under a
material
being cut.
load or does not
2. Electrical
failure.
2. Contact
Sears Service
(see back
turn when switch
cover).
is pressed.
3. Thrown circuit
breaker.
3. Check breaker box.
4. Debris
stopping
head.
4. Remove
debris.
Line breaks
1. Line improperly
routed
1. Check line routing.
while cutting,
in head.
2. Incorrect
line size
2. Use only 0.080 inch (2 mm) dia. line.
3. Dirt build-up
on unit.
3. Clean unit.
Line welds onto
1. Line size is incorrect.
1. Use only 0.080 inch (2 ram) dia. line.
cutting head.
2. Crowding
line against
2. Allow tip of line to do the cutting.
material
being cut.
Line usage is
1. Line improperly
routed
1. Check line routing.
excessive,
in head.
2. Line size is incorrect.
2. Use only 0.080 inch (2 mm) dia. line.
3. Crowding
line against
3. Allow tip of line to do the cutting.
material
being cut.
4. Cutting head worn or
4. Contact
Sears
Service
(see back
damaged,
cover).
lO
Publicidad
