Publicidad
Idiomas disponibles
Idiomas disponibles
CARTON
CONTENTS
Check carton contents
against the fol-
lowing list.
Model
358.745350
• Trimmer
• Shield
• Assist handle with wing nut and bolt
• Container
of line
Examine parts for damage.
Do not
use damaged
parts.
NOTE: If you need assistance
or find
parts missing or damaged,
call
1-800-235-5878.
ASSEMBLY
_,WARNING:
If received
as-
sembled,
review all assembly
steps to
ensure your unit is properly as-
sembled
and all fasteners
are secure.
TUBE ASSEMBLY
Upper Locking
Sleeve Assembly
Wires
Lower Locking
Sleeve Assembly
1. Align upper tube groove with
triangle on lower locking sleeve as-
sembly. Push tubes together until
they snap into place.
Upper Tube
Groove
E_
<_:::]
Alignment
Triangle
2. Try to pull tubes back apart. If the
tubes do not come apart, they are
properly snapped into place. If the
tubes come apart, repeat step 1 and
push until the tubes snap into place.
3. Slide upper locking sleeve assem-
bly over lower locking sleeve as-
sembly and tighten by turning
clockwise.
A
,l_ WARNING:
Failure to completely
enclose excess wires in upper tube dur-
ing assembly
of the unit may result in
damage to the wires and/or the unit or
serious injury to the operator including
electrocution.
_
WARNING:
The upper and lower
tubes must remain permanently
as-
sembled
together and the locking
sleeve assembly
must be fully tight-
ened before and during use to avoid
serious
injury to the operator and/or
damage
to the unit. DO NOT attempt to
disassemble
unit after initial assembly.
ADJUSTING
ASSIST HANDLE
1. Loosen and remove wing nut and
bolt from assist handle.
2. Place unit on a flat surface.
3. Firmly push the assist handle over
the tube. To make installation
easi-
er, tilt handle toward trigger hous-
ing while pushing
down (see il-
lustration).
4. Reinstall bolt in handle. Thread
wing nut onto bolt.
5. Adjust the handle up or down the
tube to a comfortable
position;
tighten wing nut securely.
1, Assist handle
housing
--_x4,_/2,"
_
,_),\
_ Tube
_
\bE
%
ATTACHING
EDGE GUIDE AND
SHIELD
_'WARNING:
The shield must be
properly installed. Tile shield provides
partial protection to the operator and
others from the risk of thrown objects.
Your unit is equipped with a line limiter
blade, which cuts excess line to the
proper length while running. The line
limiter blade (on underside of shield) is
sharp and can cut you.
5
Publicidad
