Publicidad
Idiomas disponibles
Idiomas disponibles
REVERSE
OPERATION
SYSTEM
(ROS)
Your tractor
is equipped
with
a Reverse
Operation
System
(ROS)_ Any attempt
by
the operator
to travel in the reverse direction
with the attachment
clutch engaged will shut
off the engine unless ignition
key is placed
in the ROS "ON" position,
&WARNING:
Backing
up with
the at-
tachment
clutch engaged
while
mowing
is
strongly discouraged°
Turning the ROS "ON",
to allow reverse
operation
with the attach-
ment clutch engaged,
should
only be done
when the operator
decides it is necessary
to
reposition
the machine
with the attachment
engaged_
Do not mow in reverse
unless
absolutely
necessary.
USING
THE
REVERSE
OPERATION
SYSTEM
Only use ifyou are certain no children or other
bystanders
will enter the mowing
area.
1. Move
motion
control
lever
to neutral
position,
2. With
engine
running,
turn ignition
key
counterclockwise
to ROS
"ON"
posi_
tion.
3.
Look down and behind before and while
backing.
4.
Slowly
move
motion
control
lever
to
reverse
(R) position
to start movement,
5. When use ofthe ROS is no longer needed,
turn the ignition
key clockwise
to engine
"ON" position,
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE
ON HILLS
_WARNtNG:
Do not drive
up or down
hills with slopes greater than 15 ° and do not
drive across any slope° Use the slope guide
provided
at the back of this manual,
• Choosethestowestspeed
before starting
up or down hills.
• Avoid
stopping
or changing
speed
on
hills.
• If stopping
is absolutely
necessary,
push
clutch/brake
pedal quickly to brake position
and engage
parking
brake.
• Move motion control lever to neutral posi-
tion,
IMPORTANT:
The motion control lever does
not return to neutral position when the clutch/
brake pedal is depressed.
. To restart movement,
slowly release park-
ing brake and clutch/brake
pedal.
, Slowly move motion control lever to slow-
est setting.
• Make all turns slowly°
TO TRANSPORT
When
pushing
or towing
your tractor,
be
sure to disengage
transmission
by placing
freewheel
control
in freewheeling
position.
Freewheel
control
is located
at the
rear
drawbar
of tractor.
1. Raise attachment
lift lever to its highest
position.
2.
Pull freewheel
control out and into the slot
and release so it is held in the disengaged
position,
• Do not
push or tow tractor
at more than
two (2) MPH.
• To re-engage
transmission,
reverse above
procedure.
TRANSMISSION
ENGAGED
TRANSMISSION
DISENGAGED
NOTE:
To protect hood from damage
when
transporting
your tractor on a truck or a trailer,
be sure hood is closed and secured to tractor,
Use an appropriate
means of tying hood to
tractor
(rope, cord, etc.).
TOWING
CARTS
AND OTHER
ATTACH-
MENTS
Tow only the attachments
that are recom-
mended
by and comply
with specifications
of the
manufacturer
of your
tractor.
Use
common
sense when towing.
Too heavy of
a load, while on a slope, is dangerous.
Tires
can lose traction
with the ground and cause
you to lose control of your tractor.
13
Publicidad
