Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
&WARNING:
Do not short battery termi-
nals by allowing a wrench orany other object
to contact
both terminals
at the same time,
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminal
must be connected
first to
prevent sparking from accidental
grounding.
i.
Lift hood to raised
position.
2,
Remove
terminal
cover°
3. Disconnect
BLACK
battery
cable then
RED battery cable and carefully
remove
battery
from tractor.
4,
Install new batterywith
terminals
in same
position
as old battery.
5,
Reinstall
terminal
cover_
6.
First connect
RED battery cable to posi-
tive (+) battery terminal
with bolt and nut
as shown.
Tighten
securely.
7_ Connect
BLACK
grounding
cable
to
negative
(-) batteryterminalwith
remain-
ing bolt and nut. Tighten
securely
8,
Close hood,
me
[[,m_
..................
Cover
Positive _
(Red).-.-
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove
bulb holder from the hole in
the backside
of the grill.
3.
Replace
bulb in holder and install bulb
holder securely
back into the hole in
the backside
of the grill.
4. Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring
may cause
your tractor
to run poorly, stop running,
or
prevent
it from starting.
• Check wiring.
See electrical
wiring
diagram
in the Repair
Parts manual.
TO REPLACE
FUSE
Replace
with 20 amp automotive4ype
plugqn fuse.
The fuse holder is located
behind the dash.
TO REMOVE
HOOD & GRILLASSEMBLY
1. Raise hood.
2,
Unsnap
headlight
wire connector°
3.
Stand
in front of tractor.
Grasp hood at
sides, tilt toward
engine and lift off of
tractor.
4. When
replacing
hood, be sure to re-
connect
the headlight
wire connector.
' %"_-"_
Headlight Wire
.)_1
Connector
ENGINE
TO ADJUST
THROTTLE
CONTROL
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check
adjustment
as described
below before loosening
cable. If adjustment
is necessary,
see engine manual.
TO ADJUST
CHOKE
CONTROL
The choke
control
has been preset
at the
factory and adjustment
should not be neces-
sap/. if adjustment
is necessary,
see engine
manual.
TO ADJUST
CARBURETOR
Your carburetor has been preset atthe factory
and adjustment
should
not be necessary.
However, minor adjustment
may be required
to Compensate
for differences
in fuel, tem-
perature,
altitude or load. tf the engine does
need adjustment,
see engine manual.
26
Publicidad
