Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
TO AVOID
SERIOUS
INJUR'._ BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1. Depress
clutch/brake
pedal fully and set parking
brake.
2o Place motion control
lever in neutral
position.
3.
Place attachment
clutch
in "DISENGAGED"
position.
4.
]'urn ignition
key to "STOP" and remove
key.
5_ Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark plug wire from spark plug and place wire where
it cannot
come in contact
with plug.
TO REMOVE
MOWER
1. Place
attachment
clutch
in "DISEN-
GAGED"
position.
2.
Lower attachment
lift lever to its lowest
position.
3.
Roll belt off engine
pulley
(M) and belt
keepers
(G).
4.
Remove
retainer
spring
(K), slide collar
(L) off and push housing
guide (P) out
of bracket.
5.
Remove
clutch
cable
spring
(Q) from
idler arm (R)o
6.
Disconnect
front
link (E) from mower-
remove retainer
spring and washer.
7. Go to either side of mower and discon-
nect mower
suspension
arm (A) from
chassis
pin (B) and rear lift link (C) from
rear mower bracket (D)- remove retainer
springs
and washers°
_, CAUTION:
After rear lift links are discon-
nected, the attachment
lift lever will be spring
loaded.
Have a tight grip on lift lever when
changing
position
of the lever.
8.
Slide mower out from under right side of
tractor.
IMPORTANT:
If an attachment
other than
the mower is to be mounted
on the tractor,
remove
the front link (E) and rear lift ]iks
(C) from tractor
and hook the clutch spring
(Q) into the cable
guide
on front edge of
lower dash.
TO INSTALL
MOWER
Be suretractor
is on level surface and engage
parking
brake.
1.
Lower attachment
lift lever to its lowest
position.
CAUTION:
Lift lever
is spring
loaded.
Have a tight grip on lift lever, lower it slowly
and engage
in lowest
position.
NOTE:
Be sure
mower
side
suspension
arms (A) are pointing
forward
before sliding
mower under tractor.
2.
Slide mower under tractor
until it is cen-
tered under tractor.
21
Publicidad
