Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
,
Clean engine,
battery, seat, finish,
etc.
of all foreign
matter.
•
Clean debris from steering
plate.
Debris can restrict clutch/brake
pedal
shaft movement,
causing
belt slip and
toss of drive°
,_ CAUTION:
Avoid
all pinch
points
and
movable
parts
Clutch!brake pedal
Steering
,
[ C_UTION:
Steering System, Dash,
Pinch
Fender and Mower _,,,l.ot Shown
Points
•
Keep finished
surfaces
and wheels
free of all gasoline,
oil, etc.
•
Protect
painted
surfaces
with automo-
tive type wax.
We do not recommend
using a garden hose
or pressure
washer
to clean
your
tractor
unless
the
engine
and transmission
are
covered
to keep water out, Water in engine
or transmission
will shorten the useful life of
your tractor.
Use compressed
air or a leaf
blower
to remove
grass,
leaves and trash
from tractor
and mower.
DECK WASHOUT
PORT
Your tractor's
deck is equipped
with a wash-
out port on its surface as part of its deck wash
system,, It should be utilized after each use,
1.
Drive the tractor
to a level, clear spot
on your lawn, near enough
to a water
spigot for your garden hose to reach,
IMPORTANT:
Make
certain
the
tractor's
discharge
chute is directed AWAY from your
house,
garage,
parked
cars, etc. Remove
bagger chute or mulch cover if attached.
2.
Make sure the attachment
clutch control
is in the "DISENGAGED"
position,
set
the parking brake, and stop the engine.
3.
Thread
the nozzle adapter
(packaged
with your tractor's
Operator's
Manual)
onto the end of your garden hose.
4.
Pull back the lock collar of the nozzle
adapter
and push the adapter
onto the
deck washout
port at the left end of the
mower deck. Release the lock collar to
lock the adapter
on the nozzle.
IMPORTANT:
Tug hose ensuring
connec-
tion is secure.
5_
Turn the water on o
6.
While sitting in the operator's position on
thetractor,
re-start the engine and place
the throttle lever in the Fast "._" position.
IMPORTANT:
Recheck
the area
making
certain the area is clear.
7.
Move the tractor's attachment
clutch con-
trol to the"Engaged"
position. Remain in
the operator's
position
with the cutting
deck engaged until the deck is cleaned.
8.
Move
the tractor's
attachment
clutch
control
to the "DISENGAGED"
posi-
tion. Turn the ignition
key to the STOP
position to turn the tractor's
engine off,,
Turn the water off.
9.
Pull back the lock collar of the nozzle
adapter
to disconnect
the adapter
from
the nozzle washout
port.
10,, Movethetractorto
adry area, preferably
a concrete
or paved area. Place the at-
tachment clutch control in the "Engaged"
position to remove excess water and to
help dry before putting the tractor away.
WARNING:
A broken or missing washout
fitting could expose you or others to thrown
objects from contact with the blade.
•
Replace broken or missing washout fitting
immediately, prior to using mower again,
.
Plug any holes in mower with bolts and
locknuts.
20
Publicidad
