Settings Menu; User Menu; Remaining Credit; Dose Settings - LAVAZZA EP 2500 PLUS Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 75
To access and navigate the items within the Set-
tings Menu please use the following functions on
the selection keypad which are each assigned to a
separate button.
Enter
Esc
To access the Settings Menu please start the ma-
chine by pressing and holding the "Enter" button
for approximately 3 seconds. With the keys 4 and 5
the display can be scrolled between the following
items:

User menu

by confirming with "Enter" the "User Menu" is
accessed.

Settings menu

by confirming with "Enter" the "Setting Menu"
requires a password:
PASSWORD
If you do not have a password, it will only be possi-
ble to access the level one menu. Password knowl-
edge on the other hand allows access to the level
two menu.
USER MENU
1
Press "Enter". You can navigate between the
following items in the level one menu by using
buttons 4 and 5.

Remaining credit

Dose settings

Water softener installation

REMAINING CREDIT
By confirming the "Remaining Credit" item with "En-
ter", an indication of the remaining supplies still avail-
able from the machine will appear on the display.
LAVAZZA EP PLUS
CREDIT 00050
Press the "Esc" button one or more times to go back
SETTINGS MENU
4
1
2
5
3
6
to previous menu levels or to exit the menu.
DOSE SETTINGS
By confirming the "Dose Settings" item with "Enter",
you can change, within preset limits, the different
selection parameters. In fact the lower level menu
allows you to choose the selection you want to
change using buttons 4 and 5.
Product 1
. .
. .
Product 6
Selection of a product with the "Enter" button, then
using the 4 and 5 buttons, gives the following pa-
rameters for which the default values are:
Offset pump
(allows you to change the pump activation time)
Confirming with the "Enter" key, the following will
appear on the display:
SET UP OK
You can then change the default value using the 4
and 5 buttons. Every time you press the buttons the
activation time for the parameter you are chang-
ing increases or decreases by 0.5 seconds. Only in
the case of the pump, if the settings have been
programmed on the basis of dose, a 0.5 increase or
decrease corresponds to a dose increase step cal-
culated in cc. The selection can then be confirmed
using the "Enter" button. Press the "Esc" button one
or more times to go back to previous menu levels or
to exit the menu.
WATER SOFTENER INSTALLATION
By confirming the "Water softener installation" with
"Enter", the functions of counting the processed li-
tres can be activated or deactivated and the display
shows the corresponding messages.
Activate now
By pressing OK, the message "ACTIVATION IN PRO-
GRESS" is shown and the machine dispenses ap-
proximately half litre of water from the soluble
nozzle. From this moment on, the litre count starts
based on the set limit and if enabled, it will be dis-
played the message "REPLACE SOFTENER".
A container can be used under the nozzle to collect
water during the filter activation process. When fin-
ished, in each case, it will be reported on the display
to verify that the drip tray is not too full of water.
E N
0
25

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lb 2500 plus

Tabla de contenido