Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Door Reinstallation
1. Install hinge assemblies:
• Install top hinge loosely with 5/,,, hex head
sc rews.
• Install center hinge with Phillips
sc rews.
2. Place hinge side of refrigerator
door
on center hinge pin.
3. While holding refrigerator
door
/
upright, tighten
down top hinge
J
with 5/,6"hex head driver.
4. Reconnect two-pin
connector.
5. Replace top hinge covers.
f
Handles
Fresh Food Handles
Materials
Needed:
• Gloves to protect hands.
• Phillips screwdriver.
• Plastic door removal card (or '/32"thick plastic card),
Retain the card.
To Install:
1. The handles are to be oriented
as shown.
2. Align front mount door handle
clip with the door tabs.
3. Ensure the handle clips are
positioned
slightly above the
door tabs.
andle
Cl p
Door
Tab
4. Rotate the handle so that the
handle is flat against the door.
5. Push the handle down against the
upper door tab just enough to
allow it to hang unsupported.
Align bottom of handle with lower
door tab. Press upper handle end to
door surface and firmly grasp lower
end of handle. Gently slide handle
upward until bottom of handle
settles on door surface, then
reverse direction, sliding downward
to almost engaging tab with clip.
Grasp the handle firmly and slide
down until it clicks. The audible
click indicates fastening
clips are
securely interlocked.
To Remove:
1. Flex the handle away from the door
panel. Simultaneously
place door
handle removal card underneath
the base of the lower handle. Insert
the card to the line or until it stops.
2. Grasp the lower part of the handle
firmly and lift to remove.
11
Publicidad
