S&P CAD-REG Manual página 36

EN
Note: When starting the regulator, the regulator model is indicated on the display: rEg.Hr.
36
Fan speed setpoint indication
Current fan speed indication
Active air quality function (CO
Not used
Temperature measurement alarm/s (Tint and Text sensors / probes)
Off: Correct temperature measurements.
On: Measured temperature fault / s (opening or short circuit).
Total keypad lock
If the active lock is operating mode lock, this icon is displayed for a few seconds after pressing
the MODE key.
Not used
OP: OFF according to schedule
OL: OFF local
Fan speed (0%...99%) (if fan speed display is allowed on display)
Current fan speed (0%...99%) (if fan speed display is allowed on display)
Temperature setpoint (3%...99%).
HF: Operating hours fi lter / s.
In parameter mode it indicates the parameter number.
Degrees Celsius
It is displayed only when the temperature setpoint is being displayed.
Not used
Temperature measurements (-15°C...50°C,--: Temperature probe fault).
Measurement of CO air quality (if the air quality function is enabled).
2
Note: For the fi rst 4 minutes, instead of the CO
Current time (00:00...23:59).
HF: 8888 operating hours fi lter/s).
The display can only display up to 9999h.
If the operating time is longer, it is shown on the display:
In parameter mode it indicates the value of the parameters.
In time programming mode it indicates the time that is programmed as start or stop.
Time Schedule Off
Time Schedule On
speed control)
2
88 88
Indoor temperature Outdoor temperature
8888
measurement, tdAt is displayed.
2
p
]9999