Metabo CV 18DA Manual página 14

English
(6) Align the holes when sticking the sanding paper to the
sanding pad. (Fig. 10)
4. Confirm the switch is in OFF position
CAUTION
Before installing or removing the battery, turn
the switch to the OFF position.
If the battery is inserted with the switch in the ON
position, the motor will operate unexpectedly.
5. Check battery insertion
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
OPERATION
WARNING
● Be sure to turn off the switch, then remove the
battery from the tool in the following situations:
• When stopping or ending work
• When attaching or removing accessories or
optional parts
• When maintaining, inspecting, or storing the
tool
● During operation, do not place your face or
hands near the application tool of the unit.
CAUTION
● To extend the lifetime, the tool and the lithium-
ion battery are equipped with a protection
function to stop the output. Therefore, if the tool
is overloaded, the motor may stop. However, this
is not the trouble but the result of protection
function. In this case, release the switch of tool
and eliminate the causes of overloading.
Additionally, refer to "CAUTION ON LITHIUM-ION
BATTERY". If it still does not run, request repairs
from a metabo HPT authorized service center.
14
Fig. 11
● When switching on the tool, make sure the
application tool is not in contact with the material
to be processed. Failure to do so may result in
injury.
● For cutting efficiency, switch the vibration
frequency of the application tool according to
task conditions and materials to be cut.
● Do not apply any unnecessary pressure when
operating the tool. Doing so may damage the
application tool.
● After use, be sure not to place the tool near chips
or sawdust before it comes to a full stop as the
tool may suck in those particles.
1. Switch operation
Sliding the switch towards
simultaneously activating the LED light which will light
the application tool. (Fig. 12)
To turn the main unit off, slide the switch towards
Switch
LED light
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
2. Adjusting operating speed (Fig. 13)
You can change the vibration frequency between
6,000 to 20,000 /min by adjusting the dial from "1" to
"6".
Adjust the dial for the speed that best suits your task
conditions and materials.
will switch on,
Fig. 12
.