Publicidad
Idiomas disponibles
Idiomas disponibles
Use the left/right arrows to select the cluster to program.
an-
The selected cluster fl ashes
The selected cluster will fl ash. Press the
menu:
Press the
initial channel, use the up/down arrows and the digit keyboard to enter the channel number. Press the
to confi rm and then set the cluster's end channel.
A cluster may contain a minimum of 1 channel and a maximum of 6 channels.
Using the up/down arrows, the clusters can be enabled:
•
setting the channel type (analogue, digital, OFF),
•
setting the association of the cluster at the UHF input (not available for the fi rst 4 clusters because they
can only be associated to the UHF3 input),
•
regulate the cell gain (if enabled).
Notes
•
A cluster, once activated, is associated to the UHF input you are programming. To change the default
confi guration, select INPUT in the menu INPUT UHFx- CELLy.
•
All clusters are off by default. To enable the cluster, set the channel type (analogue or digital) from the
ows
"INPUT UHFx – CELLy – CHANNEL TYPE" menu.
Follow the instructions above to program all clusters.
Clusters associated to other inputs
The clusters can be associated to three inputs UHF1, UHF2 or UHF3 by means of a fl exible matrix (see fi g.
2.1); therefore, it is possible to see the settings of the cells associated to other inputs by entering the menu
of an input.
Start channel of cluster
UHF 3
<DDDDDDDDDD> 01
Cluster number 1
E21 : E21 -
Start channel of cluster
key again to enter the setting of the cluster's initial channel and end channel. To set the cluster's
key again to enter the setting of the cluster's initial channel and end channel. To set the cluster's
CELL 1 - UHF 3
E21 : E21 -
Menu relevant to
the UHF3 input
Cluster associated
to the UHF2 input
E21 - E21
key to enter the cluster programming and display the following
CELL 1 - UHF 3
DTT
Finish channel of cluster
OFF
Start channel of cluster
UHF 3
E33 - E37
<DDDDD22112> 06
41
Finish channel of cluster *
* if the cluster is
enabled
Indication of the number of
clusters you are programming
UHF3 antenna input
associated to the cell 1
Channel type:
DTT: Digital
A: Analog
OFF: cluster off
Cluster off
Finish channel of cluster
Indication of the number of
clusters you are programming
key
Publicidad
