Publicidad
Idiomas disponibles
Idiomas disponibles
Outlet
2.
Set the Auto/Off
lever to "Off" and
unplug unit.
3.
Remove the outlet pressure gauge
and quick connect
(if equipped)
from the regulator.
7.
Unscrew
the check valve (turn
counterclockwise)
using a 7/8"
open end wrench.
NOTE the ori-
entation
for reassembly.
8.
Using a screwdriver,
carefully
push
the valve disc up and down.
NOTE" The valve disc should move
freely up and down on a spring which
holds the valve disc in the closed posi-
tion; if not the check valve needs to be
cleaned or replaced.
Screwdriver
position
nothing
is
visible.
In closed position
disc is visible.
9.
Clean or replace the check valve.
A solvent, such as paint or varnish
remover can be used to clean the
check valve.
10. Apply sealant to the check valve
threads.
Reinstall the check valve
(turn clockwise).
11.
Replace the pressure release tube.
Tighten nut.
12.
Replace the outlet tube and tight-
en nut.
13.
Replace the shroud and air filter.
14.
Perform the break-in
procedure.
See Break-in
Procedure
in the
Operation
section.
To Replace
Regulator
1.
Release all air pressure from air
tank. See To Drain Tank in the
Maintenance
section.
4.
Remove the regulator.
5.
Apply pipe sealant tape to the
nipple.
6.
Assemble
the regulator and orient
as shown.
Regulator
NOTE: Arrow indicates
flow of air.
Make sure it is pointing
in the direction
of air flow.
.
.
Reapply pipe sealant to outlet
pressure gauge and quick con-
nect.
Reassemble
outlet pressure
gauge and quick connect.
Orient
outlet pressure gauge to read cor-
rectly. Tighten quick connect
with
wrench.
17- ENG
N015838
Publicidad
