Publicidad
Idiomas disponibles
Idiomas disponibles
ILMO 2 40 WT
2. 4. 2. Restoring the original configuration
2. 4. 2. 1. Using the control point connected to the roller shutter
Follow each of the 4 steps in the procedure carefully to correctly restore the original configuration.
Place the roller shutter in the mid-height position.
1)
Repeat the next step 3 times in succession:
2)
Press the Up button until the roller shutter moves. Release the
-
button immediately.
Repeat the next step twice in succession:
3)
Press the Down button until the roller shutter moves. Release
-
the button immediately.
Press the Down button again until the roller shutter makes
4)
2 successive movements in the same direction.
The motorisation is reset to the original configuration.
-
2. 4. 2. 2. Using the wired electronic motor setting tool
Press the Up and Down buttons on the setting tool at the same
-
time until the roller shutter makes two successive up and down
movements.
The drive has been restored with the original configuration.
-
3. USE AND MAINTENANCE
This drive is maintenance-free
3. 1. RAISING AND LOWERING THE ROLLER SHUTTER
Press the "Up" button:
1)
The roller shutter rises and stops at the top stop without
-
requiring adjustment.
Press the "Down" button:
2)
The roller shutter descends and stops at the bottom stop
-
without requiring adjustment.
3. 2. OBSTACLE DETECTION
The automatic obstacle detection function protects the roller
shutter and enables obstacles to be cleared:
If the roller shutter meets an obstacle when lowered, it stops
-
automatically:
Press the Up button to release the roller shutter.
-
If the roller shutter meets an obstacle when raised, it stops
-
automatically:
Press the Down button to release the roller shutter.
-
Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1
2
3
4
x 2
7s
1
2
EN
x 3
17
Publicidad
