Sortimo Jumbo-Unit HD Instrucciones De Uso página 10

English
Installation
This symbol indicates a
fastening for which a specific
torque must be observed.
The following installation
scenarios are possible:
a) Jumbo-Unit HD on bodywork,
b) Jumbo-Unit HD on Sortimo floor panel,
c) Jumbo-Unit HD on Jumbo-Unit HD,
d) Cover plate on Jumbo-Unit HD,
e) Covering tray on Jumbo-Unit HD.
Jumbo-Unit HD on bodywork
Required tools
• Battery-powered screwdriver,
• Drill head for metal Ø 11 mm,
• Blind rivet gun,
• Torque wrench 1-25 Nm,
• Hexagon tool head A/F 13.
Required installation materials
)
1)
a • 4x required for installation.
• Included in installation kit
1000005118. Installation kit is not
included in the scope of delivery of
the Jumbo-Unit HD.
b • 4x required for installation.
• Included in installation kit
1000005118. Installation kit is not
included in the scope of delivery of
the Jumbo-Unit HD.
1) The installation materials are shown at the
end of these instructions.
Prerequisites
- Manufacturer's set-up guidelines are
available.
- Vehicle is suitable for the installation.
Installation steps
Step 1: Remove the drawer 130 & 230
▶ Pull drawer out as far as the stop.
▶ Unlock drawer. To do so, push the levers up
on both sides and hold them there.
▶ Pull out drawer.
▶ Retract telescopic slides.
10
Step 2: Enable fastening 330
A T T E N T I O N
Risk of damage to property
Components below the vehicle floor could
be damaged.
▶ Observe manufacturer's set-up
guidelines.
▶ If you feel unsure during installation,
please contact the Sortimo Service
Team (direct@sortimo.de).
▶ Position theJumbo-Unit HD at a suitable
location on the vehicle floor.
▶ Only drill into the beading.
▶ Mark the drill holes on the vehicle floor.
▶ Drill through holes Ø 11 mm.
▶ Set blind rivets b .
Step 3: Fix the Jumbo-Unit HD 431
▶ Position the Jumbo-Unit HD.
▶ Jumbo-Unit HD Fix in place using screws a.
▶ Tighten screws a to 20 Nm.
Step 4: Install drawer
▶ Pull telescopic slides right out to the stop.
▶ Insert the drawer runners in the telescopic
slides.
▶ Close the drawer by moving backwards and
forwards several times.
© Sortimo International GmbH