Publicidad
Idiomas disponibles
Idiomas disponibles
Jumbo-Unit HD on Sortimo floor
panel
Required tools
➥ Cordless combi-drill,
• Drill head for wood Ø 11 mm,
• Torque wrench 1-25 Nm,
• Hexagon tool head A/F 13,
• Rubber hammer.
Required installation materials
)
1)
c
• 4x required for installation.
• Included in the scope of delivery of
the Jumbo-Unit HD.
d
• 4x required for installation.
• Included in the scope of delivery of
the Jumbo-Unit HD.
1) The installation materials are shown at the
end of these instructions.
Prerequisites
-
Floor panel is available.
-
Installation instructions for floor panel are
available.
Installation steps
Step 1: Remove the drawer 130 & 230
▶ Pull drawer out as far as the stop.
▶ Unlock drawer. To do so, push the levers up
on both sides and hold them there.
▶ Pull out drawer.
▶ Retract telescopic slides.
Step 2: Enable fastening 531
Note: Sortimo offers floor panels which are
already marked up.
▶ Position theJumbo-Unit HD at a suitable
location on the vehicle floor.
▶ Mark the drill holes on the floor panel.
▶ Remove the floor panel.
▶ Drill through holes Ø 11 mm.
▶ Affix insert nuts d to the underside of the
floor panel using a rubber hammer.
▶ Install floor panel.
Step 3: Fix the Jumbo-Unit HD 632
▶ Position the Jumbo-Unit HD.
▶ Fix Jumbo-Unit HD in place using screws c.
▶ Tighten screws c to 20 Nm.
© Sortimo International GmbH
Step 4: Install drawer
▶ Pull telescopic slides right out to the stop.
▶ Insert the drawer runners in the telescopic
slides.
▶ Close the drawer by moving backwards and
forwards several times.
English
11
Publicidad
