AEG DBS 5534 Instrucciones De Servicio página 35

Instructions
Unpacking
• Remove any protective foils and stickers from the
soleplate.
• Pull out the required length of cable.
CAUTION:
• Do not pull the mains lead past the red maxi-
mum mark.
• Under no circumstances should you pull the
lead out to the end as this may damage the
automatic cable rewind.
NOTE:
If the red mark is visible, pull the lead in a small
amount with the help of the automatic cable re-
wind button (6). Hold the cable to avoid wrapping
• Use the cable holder to guide the connecting hose
(12).
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
The station has a total maximum wattage of 2100 W.
With this connected load a separate supply line protect-
ed by a 16 A household circuit breaker is recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
• Do not use any multiple sockets, as this device is
too powerful.
Temperature Control on the Iron (1)
The symbols on the control correspond to the following
settings:
• (Synthetics, silk)
• • (Wool )
• • • (Cotton, linen)
Water Tank (4)
• In order to fi ll the water tank by removing the seal
(2).
• Please use the funnel supplied.
• The tank volume is 0.8 litres.
• In order to prevent the contents of the tank from
leaking, do not overfi ll the tank. In this way you will
prevent any excess water from coming out of the
soleplate.
• Then re-tighten the seal.
05-DBS 5534.indd 35 05-DBS 5534.indd 35
2 .
low temperature
medium temperature
highest temperature
Water
Please use only distilled water. Do not fi ll battery water,
water from the clothes dryer and water containing
additives (such as starch, perfume, softener or other
chemicals) into the water reservoir. This could damage
the iron due to residues forming in the steam chamber.
These residues may cause impurities to the fabric when
dropping out of the holes in the soleplate.
Operation
Before Initial Use
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use,
please pass the iron a few times over an old clean
cloth.
Ironing without steam
NOTE:
• Sort out the garments according to their ironing
temperatures.
• Always set the temperature control to „0" before
connecting the appliance to a power point, or
before disconnecting it.
• Place the iron on the rest (3).
• Only connect the machine to a properly installed
safety socket, 230 V/50 Hz.
• Set the temperature on the temperature control (1).
If you have sensitive items to iron, please begin with
the lowest temperature.
NOTE:
The control lamp (14) on the iron shows that it is
heating up. As soon as the control lamp goes off
the operating temperature has been reached. Now
you can start ironing.
• Always turn the temperature control to „0" after use
and remove the mains plug (the control lamp in the
handle goes off ).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger
of burns.
CAUTION:
When using the steam iron please ensure that the wa-
ter tank is always fi lled to the required level. Operating
the device without water will damage it.
English
35
02.03.2009 8:17:33 Uhr 02.03.2009 8:17:33 Uhr