AEG DBS 5534 Instrucciones De Servicio página 37

Self-Cleaning
Due to the large amount of heat produced and the pres-
sure of the steam, residues that form in the soleplate are
removed automatically.
Cleaning
AVVISO:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down complete-
ly.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise
this might result in an electric shock or fi re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be poured out if it has been in the tank for a
prolonged period.
Troubleshooting
Fault Possible Cause
Device does Faulty mains
not work socket
The device Is the electric cir-
suddenly stops cuit overloaded?
working during
operation
During steam The temperature
operation regulator on the
water is iron is set too low
The required steam
emitted from
pressure has not
the soleplate
yet built up
of the iron.
There is too much
water in the tank
05-DBS 5534.indd 37 05-DBS 5534.indd 37
Fault
When the iron
is switched on
again you hear
loud noises in
the water tank.
During opera-
tions team is
emitted from
the seal (2).
Technical Data
Model: .................................................................................DBS 5534
Power supply: ............................................................. 230 V, 50 Hz
Power consumption:.......................................................... 2100 W
Protection class: ................................................................................Ι
Maximum fi lling quantity of the water tank: .........0.8 litres
Steam pressure ......................................................................3.5 bar
Net weight: .............................................................................. 3.3 kg
Remedy
Try another socket
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
Check the house
and low voltage directives, and has been constructed in
fuse
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
Select a higher
temperature
• Wait until the
control lamp
(7) on the base
Meaning of the "Dustbin" Symbol
lights up
• Press the steam
Protect our environment: do not dispose of electrical
jet button 2 to
equipment in the domestic waste.
3 times without
Please return any electrical equipment that you will no
touching your
longer use to the collection points provided for their
ironing
disposal.
Empty the tank
and fi ll in only the
This helps avoid the potential eff ects of incorrect dis-
stated maximum
posal on the environment and human health.
amount of water.
This will contribute to the recycling and other forms of
Please note the
reutilisation of electrical and electronic equipment.
instructions above!
Information concerning where the equipment can be
disposed of can be obtained from your local authority.
English
Possible Cause Remedy
Since the last time Press the steam
the iron was used pressure button 2
the tank seal has to 3 times in order
never been opened. to equalise the
A subpressure has pressure.
built up. During
heating ascending
air bubbles burst
inside the tank.
This is a normal
process.
The device is Please contact our
broken. service department.
02.03.2009 8:17:33 Uhr 02.03.2009 8:17:33 Uhr
37