Craftsman 139.53990DS Manual Del Propietário página 10

ASSEMBLY STEP 4
Install the Chain/Cable
1. Pull the cable around the idler pulley and toward
the trolley.
2. Connect the cable to the retaining slot on the
trolley, as shown (Figure 1):
• From below, push pins of master link bar up
through cable link and trolley slot.
• Push master link cap over pins and past pin
notches.
• Slide clip-on spring over cap and onto pin
notches until both pins are securely locked in
place.
3. With the trolley against the screwdriver, dispense
the remainder of the cable/chain along the rail
toward the motor unit into the slot on the chain
spreader, around the sprocket onto the chain
spreader and continuing to the trolley assembly.
The sprocket teeth must engage the chain
(Figure 2).
4. Check to make sure the chain is not twisted, then
connect it to the threaded shaft with the remaining
master link.
5. Thread the inner nut and lock washer onto the
trolley threaded shaft (Figure 3).
6. Insert the trolley threaded shaft through the hole in
the trolley. Be sure the chain is not twisted
(Figure 4).
7. Loosely thread the outer nut onto the trolley
threaded shaft.
8. Remove the screwdriver.
Figure 2 Chain
Spreader
"U" Bracket
Nut
Motor Unit
)rocket
Idler
Pulley
To avoid possible SERIOUSINJURYto fingers from
moving garage door opener:
• ALWAYS keep hand clear of sprocket while operating
opener.
• Securely attach chain spreader BEFORE operating.
Dispensing Carton
Lea_ e Cihspinn_ndgC a ble
to Prevent Kinking.
Keep Chain and Cable
Taut When Dispensing
Figure 1
i i
i i
Master Link_
Clip-On Sp ring"Y'q,
Master Link
Clip-On Spring _ Master
Cap
Cable
Link
i
, Hole
i
i
_ Master
Link Bar
Shaft
Hole
Master
Link Cap
Figure 3
Inner Nut
5/16"
Trolley
Threaded
Shaft
Figure 4
Trolley
Threaded
Shaft
Round
Hole
10