Packing And Transport; Safety Rules - KPC KL 310-3V Libro De Uso Y Mantenimiento

◊
Length: 80 cm.
◊
Width: 50 cm.
◊ Height: 70 cm.
•
Take the machine out of the carton box.
•
Fit the two tilling units to the main shaft using the delivered pins already assembled on the tilling units.
•
Fit the arm with spur in its place using the delivered pin.
•
Fix the handlebar to the handlebar support using the parts already assembled on the handlebar support itself.
•
The small wheel holder is fitted to the frame by means of a screw nut and a splint pin.
•
Fit the two guard-extensions to the main tiller protections fitted on the body of the machine using the proper screws and nuts. The protection
guards should reach a width of 60 cm according to the CE requirements.
•
During the transport the handle can be left unassembled by means of the threaded bush that fix it to the handlebar support. The tiller is
equipped with a front handle (see Pict.4 Ref. "A") in order to be able to lift and to transport the machine easily.
WARNING: Please, read very carefully this booklet before using your machine. Carefully using and servicing this machine, you will certainly
get satisfactory performances for a long time.
Failure to comply with these instructions may CAUSE fatal injury TO THE OPERATOR OR DAMAGE TO THE MACHINE.
•
Please read carefully the operation and maintenance manual supplied with the machine.
•
The use of the machine is forbidden to persons younger than 16 years.
•
The operator is responsible of any possible damage and he should always drive the machine carefully and safely.
•
Any person unfamiliar with the machine who has never used it is obliged to read first the instruction manual.
• Before carrying the machine always empty the fuel tank.
•
Before leaving the machine be sure that it is fully stopped.
•
Never use the machine barefoot or wearing sandals, always wear heavy shoes and long trousers. Always inspect the area where you want to
work taking off stones, branches, wires and any other thing which could be dangerous.
•
Before start working, make sure that a radius of minimum 5 mt. is completely free.
• Clean any possible leakage of fuel.
•
Always fill up the tank when the engine is off in an open space far from fires or any heating source and don't smoke during this operation.
•
Before starting the machine make sure that you can quickly stop the engine and that you are familiar with the control levers.
•
Never allow the engine to run in enclosed spaces where the highly toxic carbon monoxide could not evacuate.
•
Never start or use the machine if not completely assembled and equipped with the safety devices. Never work without the tiller protection
guards.
•
Never fix or clean the tiller blades or any other tools when the engine is running.
•
Attention! Don't work on slopes exceeding 30% (Pict..13).
•
For accidents caused by failure of these rules we will not be held liable.
Please find here below the stickers put on the machine. It is very important that they are always clearly legible to prevent any accident. (Pict..14).
In case the stickers are damaged it is absolutely necessary to replace them by ordering the original spare parts.
22

PACKING AND TRANSPORT

SAFETY RULES

KL 310-3V