Preparation Of The Appliance; Inserting The Brush; Inserting The Solution Tank (Optional) - Fimap FM33 Manual De Uso Y Mantenimiento

To insert the brush into the brush head body of the appliance,
proceed as follows:
1. Check that the plug (1) on the power cable (2) has been taken out
of the socket (3) of the mains supply(Fig.1), and if not, disconnect
it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
3. Tip the appliance back (Fig.4), block one of the rear wheels and
shift the control column backwards.
4
To insert the solution tank onto the handlebars, proceed as follows:
1. Secure the handlebar in a position at about 45° with respect to
the ground (Fig.1).
1
3. Put the solution tank on the column, so that the bottom of the tank
is anchored to the fixed bracket (2) on the column itself (Fig.4).
4. Holding the tank with one hand, move the mobile bracket (3)
down until the solution tank is locked to the column (Fig.5).

PREPARATION OF THE APPLIANCE

INSERTING THE BRUSH

2. Check that the handlebar is in the vertical position, if not, press
3
1
2
2
4. Position the brush over the hub in the brush head (Fig.5).
5. Turn the brush anti-clockwise to secure it to the hub (Fig.6).
5

INSERTING THE SOLUTION TANK (OPTIONAL)

2. Unscrewing the closing knob (1) (Fig.2) position the upper
1
2
5. Lock the position of the mobile bracket (3) by tightening the
25
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
the uncoupling lever (4) (Fig.2) and turn the handlebar to the
vertical position (Fig.3). When the handlebar is vertical, release
the uncoupling lever (4).
4
3
6
brackets beyond half of the column (Fig.3) (if it has not already
been positioned).
3
closing knob (1) (Fig.6).