Inserting The Detergent Solution (Optional) - Fimap FM33 Manual De Uso Y Mantenimiento

2
4
6. Insert the water distribution pipe (4) in the hole on the brush head
(5) (Fig.7).
5
7
Fill the solution tank only when the column is in vertical position, by
proceeding as follows:
1. Remove the solution tank cap (1) (Fig.1).
2. Fill with clean water, at a temperature no higher than 50°C.
3. Add the liquid detergent to the tank in the concentration and
manner indicated on the detergent manufacturer's label. The
formation of excess foam could damage the internal components
of the appliance, so only use the minimum amount of detergent
needed.
1
3
5
7
6
4
8

INSERTING THE DETERGENT SOLUTION (OPTIONAL)

1
2
26
6
7. Insert the solution tank tap tie chain (6) in the coupling in the tap
control handle (7) (Fig.8).
4. Insert the solution tank cap (1) (Fig.2).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: We recommend that you vacuum at intervals
the dirt-loaded foam with a vacuum cleaner for liquids.
1
3
1