ENAR GEEL 10 Manual De Operación página 48

Installing as
backup power
Transporting
and installing
the machine
en
General
Safety
Machine
vibration
10 GEEL
GEEL 3, GEEL 5, GEEL 7
Special hazards exist when installing this machine as a backup power supply. Improper
connection of generator to a building's electrical system can allow electrical current from
the generator to backfeed into utility lines. This may result in electrocution of utility
workers, fire, or explosion.
WARNING
Backfeed from the generator into the public power distribution system can cause serious
injury or death to utility workers!.
•
Connections to a building's electrical system must be made by a qualified
electrician and comply with all applicable laws and electrical codes.
If connected to a building's electrical system, the generator must meet the power,
voltage, and frequency requirements of the equipment in the building. Differences in
power, voltage, and frequency requirements may exist and improper connection may
lead to equipment damage, fire, and personal injury or death.
•
Never allow untrained personnel to operate or service the generator. The
generator set should be set up by a certified electrician.
•
Do not stand under the machine while it is being hoisted or moved.
•
Do not attach equipment to the machine when it is suspended.
•
Always transport the generator in an upright position.
•
Always position and operate the generator on a firm, noncombustible, level
surface.
•
Always make certain the machine is well-grounded and securely fastened to a
good earthen ground per national and local regulations.
•
Always remove all tools, cords, and other loose items from the generator before
starting it..
•
Do not operate the generator when open containers of fuel, paint, or other
flammable liquids are near.
•
Do not operate the generator, or tools attached to the generator, with wet hands.
•
Do not run the electrical cords under the generator, or over vibrating or hot parts.
•
Do not enclose or cover the generator when it is in use or when it is hot.
•
Do not overload the generator. The total amperage of the tools and equipment
attached to the generator must not exceed the load rating of the generator.
•
Do not operate the machine in snow, rain, or standing water.
•
Do not stand on the machine.
Generators vibrate in normal use. During and after the use of the generator, inspect the
generator as well as extension cords and power supply cords connected to it for
damage from vibration.
•
Have damaged items repaired or replaced as necessary.
Do not use plugs or cords that show signs of damage such as broken or cracked
insulation or damaged blades.
PORTABLE GENERATOR