SOMFY Ysia 1 Zigbee Manual De Instrucciones página 5

Idiomas disponibles

Ysia 5 Zigbee

Ysia 1 Zigbee

1.8.Channel selection on Ysia 5 Zigbee

Before using Ysia Zigbee, check that the correct channel has been selected.

A short press on the channel selector displays the selected channel.

Successive presses change the selected channel.

The LED for each channel from 1 to 4 lights up individually then all the LEDs light up

for the selection of channel 5.

NOTICE

Each channel can be used with different products or group of products.

2.INSTALLATION

2.1.Commissioning with a control point

This chapter describes the commissioning of the drive with a control point, without using the TaHoma pro application.

This configuration is referring to TaHoma ready solution.

For commissioning using the TaHoma pro application, please refer to chapter Commissionning with TaHoma pro.

2.1.1.Introduction

Creation of a network from a control point without TaHoma switch is possible to have a first implementation. This network

will only be accessible to specific compatible products. Each control point creates its own interface with its products in a

unique network of its own.

NOTICE

In the case of several control points in the same installation, the network must first be shared between the new

control points and the existing network to avoid breaking links with already paired products.

2.1.2.Add control points in the installation

If a new control point is needed on the installation (to control the same drive), the

first step is to share the network of the control point(s) already in place with the new

control point.

CAUTION

Move the control point away from the drives to avoid modifying the drives settings with the control point (during

these operations with a control point, the drives must not make any movement).

Ysia 5 zigbee 1871153 1871154