Kichler True 310452 Manual De Instrucciones página 10

INSTALLATION OF SAFETY Cable
(required for Canadian installation ONLY)
A safety support cable is provided to help prevent the ceiling fan from falling, please
install it as follows.
Step 1. Attach the wood screw and washer to the ceiling joist next to the ceiling
mounting bracket but do not tighten. (Fig. 11)
Step 2. Adjust the length of the safety cable to reach the screw and washer by pulling
the extra cable through the cable clamp until the overall length is correct, put the end of
the cable back through the cable clamp, forming a loop at the end of the cable. Tighten
the cable clamp securely. Now, put the loop in the end of the safety cable over the wood
screw and under the washer. Tighten the wood screw securely.
NOTE: Although the safety support cable is required for Canadian installations only, it's a
good idea to make the attachment with any installation.
ELECTRICAL CONNECTIONS
CAUTION: To avoid possible electrical shock, be sure you have turned off the
power at the main circuit panel.
Step 1. Insert the receiver into the ceiling mounting bracket with the flat side of the
receiver facing the ceiling. (Fig. 12) For best performance, make sure the black antenna
wire (on the end of the receiver) remains extended, and does not become tangled with
the electrical wires.
10 | KICHLER.COM
Ceiling Mounting
Bracket
Attach safety cable
to ceiling joist with
wood screw and washer
Fig. 11
Ceiling Mounting
Bracket
Receiver
Fig. 12