Grundig GDKP5460BC Manual Del Usuario página 13

5 Installation of appliance
The information required to make the location suit-
able for the installation of the hood is given below.
5.3 Wall mounting
• Wall must be flat, straight and have the suffi-
cient bearing capacity.
• Depth of drilling holes must comply with the
length of bolts.
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 7)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpen-
dicular to the lower edge of the hood (Figure 7).
Fix the assembly scheme on the wall. For points A
and B, take the maximum dimensions of the hood
as reference, and drill points A and B you have
marked with a Ø6 mm drill bit, and tap Ø6 mm
plastic wall plugs. Install the chimney connection
Cooker Hood / User Manual
F
4x
Ø10m m
plate to the wall with 2 pieces of 3.9x22 screws
(Figure 8).
To install the hood body, drill points C,D,E,F spec-
ified in the installation template with a Ø10 mm
drill bit and tap Ø10 mm plastic dowels to these
points (Figure 8).
Install 2 pieces of 5.5x60 mounting screws to
points C and D with a clearance of 5 mm between
the screw head and the wall (Figure 8).
(Figure 8)
Install two pieces of hanging plates to the body
of the hood with M5x35 mounting screws
(Figure 8).
(Figure 9)
13 / EN