Swingline Stack-and-Shred 250X Manual De Instrucciones página 7

CD Shredding
A separate CD tray is provided to collect the shredded CD shards,
ensure that this is correctly mounted onto the bin before shredding.
Lift up the paper loading door (see fig 4).
1
Always insert CDs in the CD slot (see fig 5). Only shred one CD at a
2
time.
Close the paper loading door.
3
Empty the CD bin after 8 CDs to avoid waste spilling over into the
4
paper waste bin.
Remove the CD tray before resuming paper shredding.
5
Credit Card Shredding
Lift up the paper loading door (see fig 4).
1
Insert the credit card into the roller as shown (see fig 6). Only shred
2
one credit card at a time.
Close the paper loading door.
3
Swingline encourages customers to recycle shredded paper.
Please note that shredded paper cannot be recycled if mixed with
credit card and CD shards. If recycling, please separate shredded
paper and credit card/CD shards.
Self-cleaning Cutters
After emptying and replacing a full bin, the shredder will run in reverse
for 4 seconds, stop for 2 seconds and then forward for 4 seconds to
clear away any remaining paper from the cutter mechanism. This unique
'self-cleaning' mechanism is additional jam prevention technology from
Swingline.
7
Maintenance
The rollers on the auto-feed mechanism may become dirty over time,
please wipe clean with a dry cloth to maintain maximum product
performance (see fig 7).
The auto-start infra-red sensor, located in the paper feed entry-slot, can
occasionally become covered in paper-dust causing the shredder to
run despite no paper being fed into the machine. Switch the shredder
off at the rear of the machine and carefully clean the sensor using a
cotton-swab (see fig 8).
Lubrication of the Shredder
Only use oil sheets to lubricate. ACCO Brands accepts no
liability for product performance or safety when other types of
lubricants are used on any part(s) of this machine. Swingline
recommends using an oil sheet after the bin has been emptied
three times (and for each ongoing three bin cycle thereafter).
Insert the oil sheet into the manual feed slot and NOT in
the auto-feed chamber. Using an oil sheet in the auto-feed
chamber will contaminate the feed rollers preventing the
auto-feed mechanism shredding. Follow the maintenance
instructions if the rollers become contaminated.
Shredder Accessories
We recommend that a paper waste for recycling shredded paper is used
on all models.
Accessory
Recycling Waste Bag
Part Number
1765028