Product Use - Greencut EBW700 Manual De Instrucciones

DUST FUMIGATION SYSTEM
The dust inlet configuration involves removing the inner tubes from the reservoir, changing the inlet base, and
installing the copper wire chain.
1. Disconnect the transparent tube from the cap and base and remove it. Disconnect and remove the black
tube and also remove the filter from the reservoir.
2. Remove the tank to replace the liquid inlet base (originally mounted) with the powder base. To do this,
unscrew the tank retaining nuts (one on each side of the tank).
3. Remove the reservoir.
4. Remove the liquid intake base and insert the dust intake base until it clicks into place. Install the reservoir
again.
5. Place the gasket in the plug and screw it into the reservoir where the black tube outlet cannula was.
6. Place the chain with the copper wire on the screw of the air outlet elbow and let it loose on the other end
so that it always touches the ground when the machine is being used (the chain has to touch the ground
permanently to ground and dissipate the static electricity created inside the tube). The copper wire must be
inside the air outlet elbow.
1
4

PRODUCT USE

COMBUSTIBLE
ATTENTION: The fuel used for this machine is highly flammable. If the fuel or machine catches fire,
extinguish the fire with a dry powder extinguisher.
Engine Fuel: Mix synthetic oil and gasoline (Gasoline 25:oil 1 = 4%).
2
5
3
6
61
EN