Fuel Filter - Greencut EBW700 Manual De Instrucciones

66
5. Rinse the filter with plenty of clean water.
6. Let the filter dry.
7. When dry, moisten with 2 drops of oil (If you moisten the filter with too much oil, the machine may not
start).
8. Install the filter on the machine.
9. Put the protective cap on.
NOTE: The engine should never run without the air filter installed.

FUEL FILTER

The fuel tank is equipped with a filter. This is located at the end of the fuel intake pipe and can be removed with the
help of a hook wire.
Check the fuel filter periodically.
Do not allow dirt to enter the fuel tank to prevent the filter from getting dirty. A dirty filter will make it more difficult
to start the engine and will cause anomalies in the operation or stop of the engine.
Check the fuel. If you see dirt replace it.
If the inside of the fuel tank is dirty you can clean it with gasoline.
SPARK PLUG CHECK
The most common problems when starting a machine are caused by a dirty or bad spark plug. Clean the spark plug
and check it regularly. Check that the distance between electrodes is correct (0.6 - 0.7 mm).
CLEANING OF THE CYLINDER FINS
The fins of the cylinder are in charge of cooling the engine thanks to their contact with the air. These fins must always
be clean and without any material between them that limits the passage of air. Dirty fins will cause the engine to
overheat and you may get a cold. Regularly check the condition of the cylinder fins.