Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
RANGE
TIPPING
HAZARD
®
All rangescantipand injuryceuJd resuJt.To prevent
accidental tipping oftherange, attach itto thefloorby
installing the Anti-Tip Device supplied.
o
Ariskoftipoovermayexistiftheapplianceisnot
installed i naccordance with these instructions.
®
Install a nti-tip d evicepacked with range.
o
If the range is pulled away from the wall for
cleaning, service, o r any otherreason,ensure thatthe
Anti-Tip Deviceis propertyreengaged when the range
is pushed backagainstthewaH.Intheeventofabnormal
usage (suchas a person standing, sitting, or leaningon
an open door)_failure to take thispreoaution ceuld
resultintippingof the range. Personal injurymight
result from spilled hot liquids o r from the range itseff.
J
Improper installation, adjustment, alteration, service or
maintenance can cause injury" or property damage,
Refer to this manual, For assistance or additional
information consult a qualified installer, service agency;
manufacturer or the gas supplier,
J
WARNING
Beforeinstalling,
turnpower OFF at
theservice panel Lock service _neJ
topreventpower from beingturned
ON aocidentaHy.
Avoid drafts across the range, They" will obstruct ventilation
and combustion,
o Never modify or alter the construction
of a range by
removing leveling legs, panels, wire covers, anti-tip brackets,/
screws, or any other part of the product,
Notice: DO NOT LIE RANGE BY DOOR HANDLE, Remove
the door for easier handling and installation.
See Section
'Removing Oven Door' in Use and Care manual.
f
For Massachusetts
Installations:
1. Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter qualified or
licensed by the state, province or region where this
appliance is being installed.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36
inches.
HIGH ALTITUDE IN$TALU_,T_ON NOTE:
For installation at altitudes above 2,000 ft., contact Bosch
Service (800-994-290zt) for special instructions.
IMPORTANT:
LOCAL
CODES
VARY.
INSTALLATIONr
ELECTRICAL
CONNECTIONS
AND GROUNDING
MUST COMPLY
WITH ALL
APPLICABLE CODES.
Proper Installation
=Be sure your appliance is properly
installed and grounded by a qualified technician in accordance
with the National Electrical Code ANSIiNFPA No. 7 latest edition
and local electrical code requirements.
This appliance has been tested in accordance with ANSI Z21.1,
Standard for Household Cooking Appliances (USA) and in ac-
cordance with CAN 1.1-M81 Interim Reqt #58 Domestic Gas
Cooktops (CANADA).(In Canada, installation must be in accor-
dance with the CAN 1-B149.1 and .2 Installation Codes for Gas
Burning Appliances and/or local codes).
The following must be met when testing supply piping system:
a)
The appliance and its individual shut-off valve must be
disconnected from the gas supply piping system at test
pressures in excess of :[/2 psig (3.5 kPa).
b)
The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 psig (3.5 kPa).
ElectricalSpecifications:
Ranges are rated for use on a :[20 Vi 15 AMP circuit.
TO PREVENT ELECTRICAL SHOCK, THE GROUNDING PRONG
SHOULD
NO%
UNDER ANY CIRCUMSTANCES,
BE CUT OR RE-
ROVED. IT MUST BE PLUGGED INTO A MATCHING GROUNDING
TYPE RECEPTACLEAND CONNECTED TO A CORRECTLY POLAR-
IZED :[20-VOLT GRCUIT,
A separate, non GFC[ circuit is recommended unless local code
specifies otherwise.
If there is any doubt as to whether the wall receptacle is prop-
erly grounded, have it checked by a qualified electrician.
Page 3
Publicidad
