Publicidad
Idiomas disponibles
Idiomas disponibles
When extending the frame beyond 1720mm, the trough (4) must be
mounted in the middle of the support beam. The length of the support beam
should not exceed the position of the hole (x) marked in the above drawing.
Secure the trough to the side beam as described in method one.
3.3.
Working with the unit
1. Connect the unit plug to a power outlet.
2. Adjust the height of the desk frame in one of the following ways:
a) Manually using the buttons (12) and (13). The display (11) will show the
current desk height.
b) By recalling one of the three previously saved desk height settings by
pressing one of the buttons 1 (14), 2 (15) or 3 (16).
Saving position settings is described later in this manual.
c)
Caution: Verifying the correctness of the display after the first start-up of
the unit is recommended.
If necessary, perform a reset according to the instructions in point 6.
3. Storing the desk height settings in the memory.
Set the preferred desk height using the keys (12) and (13).
Then press the M button (17), "S-" will appear in the display.
Now choose under which number to store the position by pressing one of
the buttons 1 (14), 2 (15) or 3 (16), depending on the chosen number the
display will show "S-1", "S-2" or "S-3".
4. Reminder function for changing position at the desk
- Press button A (18) to activate the function. The display will show "ON" or
"on".
Publicidad
