Cata RENOVA PURE AIR MNV90 GWH Instrucciones Para El Uso página 9

ON/OFF AND INCREASE/DECREASE THE FAN SPEED
Press the decrease fan speed (
Press the increase fan speed icon (
If the fan motor is set at speeds 2,3,4, 5 or P, pressing the Fan Decrease (
the speed by one level at a time. If you press the Fan Decrease (
seconds, the fan will turn down. However, the downlight will remain on 8 if enabled).
If the fan motor is set at speed 1, pressing the Fan Decrease (
off. However, the downlight will remain on (if enabled) and the display will show the current
brightness level.
Boost Function
If the fan motor is set at speeds 1,2,3,4 or 5, pressing the Fan Increase (
the speed by one at a time. If you press the Fan Increase (
the speed will increase to full power from any level and the display will "P".
Light On/Off (
Touch the Light (
To change the brightness of the downlight, touch and hold the Light (
show the brightness sequence. Remove your finger from the Light (
brightness is achieved. The sequence runs from L1 to L5 and back to L1 in steps. The selected
brightness will flash for a few seconds and revert to the fan speed display. This lighting setting
will be kept for future uses.
Setting the timer (
• When the fan motor is on and the Timer (
the display will show the current fan speed.
• The chosen speed level will remain in use for five minutes before dropping down to the
next lowest speed. This speed will remain in operation for two minutes before dropping
down again. This will be repeated every two minutes unless the speed is already at level 1
and then the fan will turn off. If the light is already on, this will also be turned off.
• Pressing the Fan Decrease (
program will restart the countdown process again with the first five minutes cycle.
• If the Timer (
cancelled. The Timer (
on indefinitely.
• The maximum timer program cycle is 15 minutes: 5 minutes: 5 minutes on O and then 2
minutes each on speed 5 down to speed 1.
Filter cleaning warning
Once the cooker hood is off, if the Timer icon (
)", you should clean the filters. Once they are cleaned or replaced, press the Timer (
again and the icon will turn off.
(Only in Recirculation mode). Once the cooker hood is off, if Timer (
the LED display shows "(
ble carbon filters) or replace them ( in case you are using disposable carbon filters). Once they
are cleaned or replaced, press the Timer (
60822055.22.02.2023.indb 9 60822055.22.02.2023.indb 9
) icon and the fan will turn on at speed 1.
) and the fan will turn on at maximum speed (Booster)
)
) Icon to turn on the downlight.
)
) Icon or Fan Increase (
) icon is pressed again during a current timer program, the cycle will be
) Icon will revert to white and the current fan speed will remain
)" , you should clean the carbon filters (in case you are using washa-
) Icon for more than three
) Icon the motor will switch
) Icon for more than two seconds,
) Icon when the desired
), icon is pressed the icon will turn in red and
) Icon during a current timer
) blinks in red and LED display shows "(
) icon again and the icon will turn off.
) Icon will reduce
) Icon will increase
) Icon until the display
) icon
) icon blinks in red and
15/5/23 9:25 15/5/23 9:25
EN
9