1. GENERAL WARNINGS
EN
1.1. IMPORTANT
Connect the power cable to an earthed 220-240V 50-60Hz socket that is located
in a safe and dry area.
Means of disconnection must be incorporated into the xed installation in
the electrical connection of the appliance, in accordance with the installation
regulations in force in the country in which it will be installed.
Before proceeding with the connection, verify that there is no voltage in the
network for safety reasons.
Make sure that the supply voltage is the one indicated on the name plate before
connecting the appliance to the mains.
The device must be connected to the protective conductor of the xed
installation. It has to be plugged into a grounded outlet.
Any incident derived from non-compliance with these instructions will
invalidate the guarantee.
Pay close attention to the to the electrical diagram in this instruction manual
with particular notice to the colours of the cables.
1.2. MAINTENANCE
The storage does not require special maintenance. To clean, use a soft, dry cloth, only when the
storage is disconnected and cold.
NEVER USE SOLVENTS, CLEANING PRODUCTS OR ABRASIVE PRODUCTS.
1.3 RECYCLING
Where you see this symbol on any of our electrical products or packaging, it
indicates that the relevant electrical products should not be disposed of as
general household waste in Europe. To ensure the correct waste treatment of
the product, please dispose of it in accordance with any applicable local laws
or requirements for disposal of electrical storage. If you doing so, you will
help to conserve natural resources and improve standards of environmental
protection in treatment and disposal of electrical waste.
22
ECOJOULE