GreenWorks 48T15 Manual Del Operador página 8

EN
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
5
8.6 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.7 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (16).
2. Remove the battery pack from the machine.
9 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
15
WARNING
16
IMPORTANT
WARNING
English
9.1 START THE MACHINE
1. Push the lock-out button (2) and pull the trigger (3).
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade cuts
the excess length.
9.4 ADJUST THE CUTTING
DIAMETER
The machine is set at a 13 in. (330 mm) cutting diameter.
You can adjust to a 15 in. (381 mm) cutting diameter.
Set the cutting diameter to 13 in. (330 mm) for greater
runtime and 15 in. (381 mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Move the cut-off blade (17) forward or rearward.
4. Tighten the blade screws.
8
2
3
NOTE