Reiner jetStamp 792 Manual De Instrucciones página 62

jetStamp 792/792 MP
2.1.6. Limit values (numberer)
Definition of the limit values that the numberer counts from and to,
e.g. starting at 10, stopping at 20 and starting again from 10.
Setting limit values
Press [MODE] until [COUNT] appears in the display menu bar.
f
Press [COUNT] until the required minimum value is set.
f
Press [MODE] until [N1 MIN] appears.
f
To save the minimum value, press [N1 MIN].
f
[N1 MIN] changes to [N1 MIN t].
Press [MODE] until [COUNT] appears.
f
Press [COUNT] until the required maximum value is set.
f
Press [MODE] until [N1 MAX] appears.
f
To save the maximum value, press [N1 MAX].
f
[N1 MAX] changes to [N1 MAX t].
The limit values are now set.
Deleting limit values
Press [MODE] until [N1 CLR] appears in the display menu bar.
f
To delete the set limit values, press [N1 CLR].
f
2.1.7. Stamping a constant number
You can also stamp using a number that doesn't change.
Imprint P : 08 to P : 10 must be chosen (see "Selecting imprint" on page 63).
Press [MODE] until [NO/TXT] appears in the display menu bar.
f
Press [NO/TXT].
f
"INPUT - PRE TEXT" appears.
Press [NEXT].
f
"INPUT - NUMBERER 1" appears.
Press [VARY].
f
To increase the number value, press [INC].
f
To decrease the number value, press [DEC].
f
In order to move one digit to the right and modify this with [INC/DEC],
f
press [RIGHT].
Special characters can be set at each digit position.
To save changes and to return to the main menu,
f
press [RETURN] twice.
The main menu appears.
60