Reiner jetStamp 792 Manual De Instrucciones página 80

jetStamp 792/792 MP
5.3. Clean Nozzles
If there is stripe formation or if any problems occur with the print quality, there may be dried
ink in the nozzles
To warrant high print quality, the nozzles should be cleaned at regular intervals.
For notes on temperatures and humidity, see "Technical Data" page 82 and in the
accompanying documents of the cartridges.
To avoid drying of the ink at the nozzles
climatic conditions of the environment (see "Selecting cleaning interval", page 65).
5.3.1. Automatic Nozzle Cleaning
WARNING
Danger of blinding at contact of the ink with the eyes.
Do not point the jetStamp 792's nozzles
f
Trigger automatic cleaning mechanism
A small amount of ink is ejected to clean the nozzles
Put jetStamp 792 in base station
f
Push [MODE] until the menu bar [CLEAN] appears.
f
To start cleaning, push [CLEAN].
f
5.3.2. Manual Nozzle Cleaning
Manual Nozzle Cleaning
If automatic nozzle cleaning does not bring the desired result,
we recommend the following measure:
To loosen the dried ink, gently wipe a soft cloth possibly moistened slightly with Ethanol
f
(spirit) against the nozzles
Dab off dissolved ink and wipe dry the nozzles
f
5.4. Selecting Cleaning Interval
See "Cleaning Interval", page 65.
f
78
16
.
4
.
Fig.
E

16
for approx. three seconds.
16
16, adjust the cleaning interval to the
16
towards the face of persons!
Fig.
A

16
.
16
.