■
Selection of installation place
Avoid installation in the following kinds of locations.
• Dx-coil interface is recommended to be installed indoors. Install it in
a location where there is no rain, wind, and direct sunlight.
• Do not install in locations where there is a machine generating high
frequency. Failure to do so may cause a wrong operation or an
abnormality.
• Do not install in locations with atmospheres with mist of oil
(including machine oil) or dense vapor, or locations containing
salt such as the coast area, or locations with acidic or alkaline
atmospheres, or locations where sulfurizing gas are generated such
as areas with hot springs. Use in inappropriate locations result in
malfunctions.
• Do not put any vessel contains the water in the vicinity of the indoor
unit (including Dx-coil controller, Dx-valve kit).
If the water spills and enters into the inside of the unit, the electric
insulation deteriorates and may result in an electric shock.
• Make sure that the air fi lter is attached on the indoor unit. If it is not,
the dust clogs in the heat exchanger etc. in the air conditioner and
may result in water leakage or defrosting.
• Separate the television or radio from the air conditioner or remote
controller at least 3' 4" (1 m.) Failure to do so may cause the
disturbance of the image, or the noise.
• Do not use for special-purpose (Foods, animals and plants,
precision machine, storage of the artwork etc.).
• Do not use in locations where there is anything that would be
compromised by wetness. The mist or water dew drop may result in
damage.
• Do not install in locations where organic solvents are being used.
• Do not install in locations near doors or windows where the air
conditioner may come into contact with high humidity outside air.
Condensation may occur as a result.
• Do not install in locations where special sprays are used frequently.
The location has an impact on the insulation of the equipment and
may cause the ignition.
- 4 -
EN