GLO hyper X2 AIR Manual Del Usuario página 3

QUICK START GUIDE
4
Please refer to the product diagram on the first
page.
• Open the shutter door
EN
• Insert the tobacco stick into the
heater chamber
• Turn on the device by holding down the
Standard mode button
Boost mode button
• Wait for the next vibration, the stick is now
heated and ready for the session. Lift the
product with the tobacco stick inserted into it
and inhale gently.
• When the device vibrates again, you have
10 seconds left. After the session, remove the
tobacco stick, dispose of it responsibly and close
the shutter door
• You may also stop your session earlier by
holding down either of the control buttons for
2 seconds
Before the first use, charge the device in
line with the safety instructions, using the
USB-C charging port
LED INDICATION
During the session, the LED indicator
illuminated in Ice Blue (Standard mode selected)
or Blue (Boost mode selected).
When the device is not connected to a charging
source, it is possible to check the charge status
with a short click on the Control button:
OFF RED
0% <10%
1 .
.
2
or
3
for 3 seconds
4
1
7
5 will be
ORANGE YELLOW GREEN
11-30% 31-60% 61-100%
When connected to the charging source, the LED
Indicator will display di erent colours to indicate
the current charge status:
OFF RED ORANGE YELLOW GREEN
0% <10% 11-30%
For LED indication of the troubleshooting, please
refer to the online guide.
CLEANING
Ensure the product has been allowed to
cool for a minimum of 10 minutes before
cleaning.
After every 5 sessions, open the cleaning door
and use a tissue to wipe away any moisture.
After every 20 sessions, open both the shutter
and the cleaning doors and use the brush
provided to clean the heating chamber from both
ends. Rinse the brush under running water and
allow to dry before using it again.
Please do not interfere with the safety valve
(rubber door between 6
31-60% 61-100%
6
and 7 ).
5
EN