VEVOR SKF-B40F Manual De Instrucciones página 11

finished.
Self-cleaning:
1. When the machine is turned off while connected to the power, press the
"Reservation/Clean" button and hold it for a while. The machine will
automatically enter self-clean program.
Notes:
1)If you change the countdown time during the middle of the ice making
procedure, it will take effect at the next loop. You can long press the "HOT"
button during the ice making to unload the ice cubes ahead of time.
2)The surrounding environmental temperature will influence the time
needed for ice making.
CLEANING & MAINTENANCE
Please thoroughly clean your ice maker before initial use.
Exterior: the outside of the ice maker should be cleaned regularly with a
mild detergent and warm water. Always use a soft cloth to avoid scratching
or damaging the housing.
INTERIOR: please use the following Self-Clean function:
1.Add water and vinegar or lemon juice mix (1:1 ratio)
2.Plug in unit,press and hold the CLEAN button for approximately 3
seconds,then release.The unit will automatically enter Self-clean program.
This process takes about 5-6 minutes.When the Self-Clean program is
finished,unit will automatically power off.
3.The fan blade will be rotating.This process rinses the inside parts several
times.
4.After the Self-Clean program is completed,unplug the power cord and
drain out the water by unplugging the drain cap on the side.Replace drain
cap.
5.Add fresh water to the water reservoir,up to the water level mark.
6.Plug the unit and repeat the Self-Clean process by repeating steps 3 to 5.
This will rinse out the vinegar/lemon residue.
7.After draining the water,replace and tighten drain cap.
8.Dry the interior and exterior with a clean,soft cloth.
- 10 -