EN
Step 3
A foam tape is provided to seal the cooktop edges to the
countertop. Apply tape approximately 1/16" (1.5 mm) from
the glass edge to the underside of the cooktop glass. Use tape
around the entire glass perimeter. Cut off excess where tape
ends butt.
Step 4
Insert the cooktop centered into the cutout opening.
Make sure the front edge of the counter top is parallel to the
cooktop. Make final check that all required clearances are met.
6
FIGURE 7
FIGURE 8
Step 5
Four clamp brackets are provided to clamp the cooktop to
the countertop. Tighten screws just enough to hold brackets in
place when cooktop is put into cutout.
Tighten screws securely.
FIGURE 9