Infiniton TLW-D83ABH Manual Del Usuario página 26

Installation
Water supply connection
To avoid water leaks, please read these instructions carefully.
WARNING! Do not kink, crush or modify the supplied water inlet hose on the appliance.
1. Connect the water supply hose to the water inlet valve and to the cold water tap.
2. Tighten all hose nuts by hand. Never use a tool to tighten the nuts.
IMPORTANT! Models with a single water inlet must not be connected to the hot water tap. This will
damage the laundry in the appliance or may cause a general failure of the appliance.
When you have finished connecting the water connections, please pay special attention to check for
leaks at the connection points by opening the taps as much as possible. check for leaks at the
connection points by opening the taps as far as possible. If a leak is visible, close the tap and remove the
nut. Replace the nut carefully after checking the seal.
Note: Do not use old or used water hoses in your new washing machine, as they may cause stains on
your clothes.
Drain hose connection
The end of the drain hose must be connected directly to the drain or sink.
WARNING! Do not kink or lengthen the drain hose, otherwise it may be damaged due to possible
water leakage.
If the drain hose comes out of its housing during water drainage, your home could be flooded and you
could suffer burns due to the high water temperatures during the washing process. during the washing
process. Securely fix the drain hose to avoid these situations and to ensure that the drainage situations
and ensure that the water intake and drainage processes take place safely.
There are two ways of attaching the intake end of the drain hose:
Option 1. Place the end of the drain hose into the
sink, using the clamp provided, as shown in the
picture.
Note: In case you connect the drain hose as option 1, To prevent backflow of dirty water into the machine
and to facilitate draining, do not immerse the end of the hose into the dirty water and do not insert it into
the drain more than 15 cm.
Min. 70cm
Max. 125cm
26
Option 2. Connect the end of the drain hose
directly to the sink drain socket, as illustrated in the
picture.
English
infiniton.es