MN010359A01-AA
Chapter 12: Connectivity
12.2
Wi-Fi
Wi-Fi
is a registered trademark of Wi-Fi Alliance
®
device firmware, codeplug, and Voice Announcement.
NOTE: Configure your Wi-Fi system according to the latest industry security recommendations or use
Enterprise Wi-Fi.
12.2.1
Turning the Wi-Fi On or Off
Procedure:
1. Press the Voice Assistant button.
2. After you hear a tone, speak your command into the accessory microphone.
Result: If the Wi-Fi is turned on or off, the voice announcement sounds.
12.2.2
Wi-Fi Status
Initiating the voice command for Wi-Fi status allows you to get the Wi-Fi status for your device as shows in
the following table.
Table 9: Wi-Fi Status and Indications
Wi-Fi Status
Your device is connected to the Wi-Fi network.
Your device Wi-Fi is turned on but there are no Wi-Fi
signals.
Your device Wi-Fi is turned on, connected to the
Wi-Fi router, but there is no internet connection.
Your device Wi-Fi is turned off.
42
. You can set up and connect Wi-Fi network to update your
®
Indications
●
The voice announcement sounds.
●
The LED bar shows the Wi-Fi signal strength.
●
The voice announcement sounds.
●
The top and bottom crescent red LEDs blink
twice.
●
One-bar LED blinks.
●
The voice announcement sounds.
●
The top and bottom crescent red LEDs blink
twice.
●
The LED bar shows the Wi-Fi signal strength.
The voice announcement sounds and prompts
you to turn on the device Wi-Fi.
NOTE: If the turning on Wi-Fi Permission
feature is restricted, the voice announce-
ment does not prompt you to turn on the
device Wi-Fi.