Eaton TRIPP LITE Serie Manual Del Propietário página 11

Hardware Installation
1
Ground the unit by connecting one end of a grounding wire to the grounding terminal and
the other end to a suitable grounded object.
Note: Do not skip this step. Proper grounding helps to prevent damage to the unit from power surges or
static electricity.
2
Important: Before connecting the unit, set the Tx / Rx switch to define the unit. The unit
will be a transmitter if the Tx / Rx switch is set to Tx, or will be a receiver if the Tx / Rx
switch is set to Rx.
3
Connect an HDMI-enabled PC to the transmitter using an HDMI cable. You can connect
other HDMI-enabled source devices here (e.g., Blu-ray player).
4
(Optional) Connect an audio source device to the transmitter. To embed this audio input
to the HDMI output, set the HDMI audio switch (on Tx) to ON.
5
Connect the USB Type-B port of the transmitter to a USB host (e.g., PC).
6
Connect an HDMI-enabled display device to the transmitter using an HDMI cable.
7
Connect the HDBaseT ports of the transmitter and receiver with a HDBaseT3-certified
Cat6a cable (or above).
8
(Optional) Connect your speakers or audio amplifier to the receiver. To de-embed this
HDMI audio from the HDMI output, set the HDMI audio switch (on Rx) to ON.
9
(Optional) To remotely control a device connected to the receiver (e.g., TV), connect the IR
emitter to the IR port of the receiver, and the IR receiver to the IR port of the transmitter.
Note: The unit supports bi-directional IR transmission.
J
(Optional) To provide network connectivity for your PC, connect the receiver to a network
switch, then connect the Ethernet port of the transmitter to your PC.
Note: The unit supports bi-directional bypass transmission.
K
(Optional) Connect the USB-A port to a USB-enabled touchscreen.
L
Connect an HDMI-enabled touchscreen to the receiver using an HDMI cable.
M
(Optional) To remotely control a PC through serial controller, connect the RS-232 port of
the transmitter to a serial controller, then connect the RS-232 port of the receiver to a PC.
Note: The unit supports bi-directional bypass transmission.
N
Connect the power cord and the power adapter, then plug the power adapter cables into
the power jack on the units.
O
Power on all connected devices.
11