IHSTALLIHG
riNG THE D OOflS
AND HINGES
Some installations require doer removal
to get refrigerator to final location.
To avoid Severe pers0nai i
or
' Discon
i
attached
To avoid property damage, observe
protective material, prior to moving
refrigerator.
> To avoid damage or breakage to
adjusting bolt, do not use power
tools to correct leveling.
> DO NOT adjust refrigerator to be
any shorter than 68Y2tall (minus
hinge and cap). Doing so may
damage underside components.
1. Remove toe grille and bottom hinge
covers.
> Open both doors 180 degrees, or
as wide as possible to remove.
2. While pinching white collar (A) to the
blue connector (B), pull water line
from connector.
B
IMPORTANT: When reconnecting water
line, cut off tubing at first available
scored line before inserting into
connector collar.
3. Removetop hinge cover by removing
Phillips screw.
4. Close doors.
5. Unscrew %6" hex head screws from
top hinges.
• DO NOT remove either green
ground wire or wire connecting
center screw.
6. Detach main wire connector harness
and red wire harness.
> To detach main wire harness, use
a flat blade screwdriver or finger-
nail to press junction point
between two connectors to
release.
> To detach red wire harness, press
tab on underside of connector to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a ¾"hex
head driver.
16 THE D OORS
> To replace the doors, follow the steps
in Removing the Doors and Hinges
in reverse order.
IMPORTANT: When reconnectingwater
line, cut off tubing at first available
scored line before inserting into
connector collar.
8