Publicidad
Idiomas disponibles
Idiomas disponibles
9
Assemble and Adjust hand brakes
7
8
9
10
11
Warning: The hand brakes on this bike scooter were not adjusted at the factory.
Before you ride this bike scooter you must assemble and adjust the hand brakes.
Insert the barrel end of the brake cable into the hole in the brake lever. Photo 7 and 8 . Squeeze
the rear brake arm with your hand until the brake rubbers are up against the wheel rim. This will
enable the inner brake cable wire to be loose, and have enough space for you to easily slip the
barrel end of the brake cable wire into the hole in the brake lever.(The brake lever on the right
hand side connects to the rear brake.)
Loosen the anchor bolt nut, squeeze the brake rubbers against the wire rim. Pull the brake cable
wire through the anchor bolt hole until there is no Slack in the inner brake wire. Tighten the
anchor bolt nut. Squeeze the brake lever hard and then release several times. Rotate the wheel,
be sure the wheel does not wobble. There should be about 1/16 inch (1.6mm) clearance
between the wheel rim and each brake rubber. Please follow these steps for both front and rear
brake assembly.
SCOOTER MAINTENANCE
Your Scooter is a quality made scooter. With periodic maintenance and common
sense use and are your scooter can provide many years of riding enjoyment.
1. Make it a habit of checking that everything is securely tightened. Make sure the handlebars
and stem are snug, axle nuts tight and the grips are in good repair and not loose.
2. The brake operation should be tested before every sue. Check for loose brake levers, worn
3. brake pads, broken frayed or kinked brake.
NOTE: Check tires weekly for pressure (recommended pressure is printed on the
sidewall of the tire).tread wear and side wall cuts.
NOTE: Check tires weekly for pressure (recommended pressure is
printed on the sidewall of the tire).tread wear and side wall cuts.
Publicidad
