Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
1.This product is for 12V car only.Check to make sure that 3 or 4 indicator lights are illuminated(battery level is
above 50%) before you use it to jump start your car.
2.Before using the jump starter to start the engine, please keep the doors and lights off.
Step1:Insert the plug of the smart battery clamp completely into the jump starter,the clamp screen will
display the voltage of just starter,The upper small icons are displayed from left to right. You can
proceed to the next step.
Step 2:Connect the red clamp to the positive teminal(+)of the car battery and conneted the black
clamp to the negative(-)of the car battery,If the smart clip screen shows the current battery voltage,
you can safely continue the operation next step.
However:if the indicator light is on but if the screen shows "
"，voltage shows"
" with beeps
warning,it indicates :1.The battery clamp may be connected in reverse.if so,you need to disconnect the
battery clamp from the vehicle and the jump starter.
2.Adjust the clamps for maximum contact with the battery terminals.
6
Publicidad
