Publicidad
Machine Operation
Raising/Lowering the Floor-tool
!
Always ensure that chemical manufacturer's safety guidelines are followed.
Machine In Use
To operate, set water flow rate tap, lower the floor-tool, press the vacuum / water
switches, pull trigger(s).
The waste water is then retrieved by the suction floor-tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
Do not operate the machine on slopes that exceed (2%),when full.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time
to work then scrub the area a second time with the floor-tool lowered.
If streaking occurs wipe floor-tool blades clean.
NOTE: Care must be taken to reduce speed when cornering or when
manoeuvring around obstacles
!
IMPORTANT
Do not operate machine unless the
Operator Manual has been read
and fully understood.
To raise the floor-tool, ensure the floor-tool carrier is central to the machine.
Lift the lever near the base of the handle and lock into position.
WHEN HANDLING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
!
44
44
GB
!
Publicidad
