Publicidad
Idiomas disponibles
Idiomas disponibles
LEVEL CONTROL
POSSIBLE FUNCTIONING
During the programming if you do not push any button (+,-, CAL) for more than 60 seconds, the pump will get out of
programming keeping the data stored until that moment.
PROGRAMMING OF MANUAL (CONSTANT) FUNCTIONING AND VISUALIZATION
Rev 2.2
DELAY START EDITING
Push and quickly release CAL button and scroll the menu using + and – buttons
till the display shows "Delay Start". Push CAL to enter the submenu and then
by pressing + and – button choice the value in seconds (0-999). Push CAL to
confirm and ESC to go back in measuring.
The closing of the level input contact, free of tension, while the pump is working,
will cause:
1) the dosing stops
2) the green ON led blinks
3a) If the functioning is Manual or mA Input the display shows the measure of
mA input on the second row and on the first row it shows alternativenly the
writing "Level " and the value of flow rate % : "Man.xx%" (for Manual
functioning) and "Off xxx%" (for mA functioning) ; see figure on the left side.
3b) If the functioning is Pulse on the second row the display shows the value of
the programmed n if the functioning is 1xn or 1xn(M) and the number of pulses
to be received from the water-meter if the functioning is 1/n. The display shows
on the first row alternativenly the writing "Stop " and the programmed mode of
functioning see figure on the left side.
When the level contact gets opened again, the pump returns to working mode
compatible with the actual inputs.
There are 3 possible functioning:
Function Manual: constant dosing with a number of impulses per minute
programmed as follows in the next paragraph.
Function Pulse: dosing proportional to number of pulses received from a
watermeter.
Function mA Input: dosing proportional to the input current.
Push and quickly release CAL button and scroll the menu using + and – buttons
till the display shows "Function Type". Push CAL to enter the submenu and then
by pressing + and – button choice " Function Manual" and confirm pressing CAL.
The display will show "Freq." and the % stored in the last programming. Modify it
by pressing + and – button and confirm the choice pressing CAL. Push ESC
button to esc the menu and go back in measure with the Manual functioning just
programmed.
The number of injections of the pump per minute depends on the % programmed.
For example: 80% means 120 injections per minute i.e. 150 pulses/min x 0.8 =
120 pulses/min.
In Manual functioning the display shows on the first row "Man." and the %
frequency programmed.
The second row shows the measure of the input current.
Cod. 00.009.282
11
Publicidad
