Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
FRONTAL PANEL DESCRIPTION
GENERAL FUNCTIONS OF THE PUMP :
- 4 LANGUAGES MENU: ITALIAN, ENGLISH, FRENCH, SPANISH
- 3 POSSIBLE TYPES OF FUNCTIONING: Manual, mA Input, Pulse (i.e pulses receved from watermeter)
- START UP DELAY
- DEFAULT PARAMETER RESTORING
- LEVEL CONTROL
- STOP DOSING ( STAND_BY )
- REAL TIME FLOW RATE %
Default functioning : ppM
Following settings:
•
ppM =0.4
•
conc %= 5%
•
L/i = 1
•
Cc/injec= 0.20cc
DEFAULT SETTINGS RESTORE
PUMP'S CONNECTIONS
Rev 2.2
DEFAULT SETTINGS
Push and quickly release CAL button and then pressing + and – buttons select "Restore
Enter"
Push CAL to confirm the choice. The pump goes back in measure restoring in memory
the default settings and calibrations parameters.
Cod. 00.009.282
1.Display LCD 8 x 2 backlight
2.Green Led: ▪ fix = PUMP ON
▪ blinking = PUMP IN ALARM
3.Red Led: indicates the injections
4.CAL button : ▪ allows to enter in programming
▪ saves the changes
5/6. – and + buttons : ▪ allows to navigate through the
7. ESC/SBY button: ▪ puts the pump in stand_by mode
Other parameters:
Manual 80%
• mA Min: 4.0mA
• Imp.Min: 0%
• Dos Min: No
• mA Max: 20.0mA
• Imp.Max: 80%
• Dos Max:Yes
• n=1
START UP DELAY: 0 sec
A – Power cable, 230 V- 50Hz (upon request : 115 ~ )
B – Level probe connector (3 and 4 contacts). OPTIONAL
C – Watermeter connector (3 and 4 contacts) and mA input
connector (1 ( - ) and 2 (+) contacts ). OPTIONAL
E - ON_OFF switch. OPTIONAL
menu
▪ Modify the parameters values
▪ allows to exit the menu
9
Publicidad
