Publicidad
Idiomas disponibles
Idiomas disponibles
Connection and start-up
Assembly of parts in wire feed unit
Adjustment of wire brake
The wire brake must ensure that the wire reel brakes
sufficiently before the welding wire runs over the edge
of the reel. The brake force is dependent on the weight
of the wire reel and wire feed speed.
Factory setting is 15kg.
Adjustment:
•
Dismount the control
knob by placing a thin
screw driver behind the
knob and thereafter pull
it out.
•
Adjust the wire brake by
fastening or loosening
the self-locking nut on
the axle of the wire hub.
•
Remount the control knob.
4
2
5
6
1
Power
F
F
F
GAS
max. 6 Bar
3
x4
Torch adjustment (Dialog torch)
The current size/wire feed speed can be adjusted both
from the machine and the welding torch if a welding
hose with dialog torch is in use. The torch adjustment is
passive without Dialog torch.
Inching
The function is used for wire inching
e.g. after change of wire.
12
1. Mains connection
2. Power switch
3. Connection of shielding gas
4. Connection of welding hose
5. Welding hose
6. Connection of earth clamp
The pressure of the
thumbscrew is adjusted to
allow the wire feed roll
just to slide on the wire
when this is stopped at
the contact tip
Publicidad
