Makita VC010G Manual De Instrucciones página 16

Installing the filter bag
CAUTION:
Do not use a damaged filter bag.
Always use the vacuum cleaner with the filter bag
properly installed. Otherwise the vacuumed dust
or particles may be exhausted from the cleaner
and they may cause respiratory disease to the
operator.
Install the filter bag before using cleaner.
Filter bag is a throw-away type. Throw away the entire
filter bag without emptying when it has become full.
NOTICE:
When the filter bag is already full or
clogged, replace with new one. Continuous use
with the filter bag full or clogged results in reduced
suction power.
NOTICE:
To prevent dust from getting into the
motor:
— Make sure that the filter bag is installed
before use.
Do not use a broken or ripped bag.
—
Otherwise the motor may be broken.
NOTICE:
Do not fold the cardboard at its open-
ing when installing the filter bag.
NOTICE:
The filter bag for the cleaner is an
important component for maintaining the appli-
ance performance. Using non-genuine filter bag
may cause smoke or ignition.
NOTE: When the filter bag is not installed in the appli-
ance, the dust box cover does not close completely.
NOTE: A reusable dust bag is preinstalled in some
countries and regions. You can follow the same instal-
lation/uninstallation steps as for the filter bag.
1. Unlock the lever and open the dust box cover.
► Fig.7: 1. Lever 2. Dust box cover
2. Unfold the filter bag fully.
► Fig.8
3.
Open the latch and insert the filter bag into the slot
on the holder so that the side with the
first.
► Fig.9: 1. Latch 2. Slot 3. Filter bag 4. Holder
► Fig.10: 1. Marking 2. Slit
NOTE: Make sure that only the marking on the card-
board can be seen through the slit of the holder.
4. Hook the latch of the holder.
► Fig.11: 1. Latch
5. Unfold the filter bag if it is folded.
► Fig.12
6.
Lock the dust box cover securely.
CAUTION:
Be careful not to pinch your fin-
gers when hooking the latch, and when closing
the dust box cover.
Removing the filter bag
CAUTION:
Otherwise foreign objects are blown into eyes, it may
result in personal injury.
Replace the filter bag when it becomes full or clogged.
Open the dust box cover and open the latch, then take
out the filter bag.
► Fig.13: 1. Latch
Pull the strip on the side of the opening to shut the filter
bag and dispose of the entire filter bag.
► Fig.14: 1. Strip
NOTICE:
designed for single-use purposes. Using a filter bag
repeatedly may cause clogging of the filter and result
in damage to the appliance.
FUNCTIONAL
DESCRIPTION
CAUTION:
ance is switched off and the battery cartridge is
removed before adjusting or checking function on
the appliance.
Appliance / battery protection
system
The appliance is equipped with an appliance/battery
protection system. This system automatically cuts off
power to the motor to extend appliance and battery life.
The appliance will automatically stop during operation
if the appliance or battery is placed under one of the
following conditions:
Overload protection
mark enters When the appliance is operated in a manner that
causes it to draw an abnormally high current, the
appliance automatically stops. In this situation, turn the
appliance off and stop the application that caused the
appliance to become overloaded. Then turn the appli-
ance on to restart.
Overheat protection
When the appliance is overheated, the appliance stops
automatically, and the battery indicator blinks about 60
seconds. In this situation, let the appliance cool down
before turning the appliance on again.
16 ENGLISH
Handle the filter bag softly.
Do not reuse a filter bag. The filter bag is
Always be sure that the appli-
On Blinking